2.4G 6CH DSM2 レシーバー CM621

品名: REDCON CM621 receiver
バンド: 2.4GHz
チャンネル: 6ch
変調方式: DSM2
サイズ: (W x Lx H): 19 x40x9mm
重量: 4.4g
電圧範囲: 4-10v
最定電圧: 4.0v (常にこの電圧より上の供給力)
アンテナ長: 30mm
電波到達範囲: 400m (tested with JR DSX9)
互換性: (Spektrum and JR DSM2): DX6I,DX7,DX8 DSX7,DSX9 DSX11

国内在庫がない場合、海外よりの輸入品の為、通常2-3週間ですが配送時間が予想以上にかかる場合があります。急ぐ人はご遠慮ください。

以下、注意事項・バインド手順他参考に
Features:
Patent pending Model Match prevents flying a model using the wrong model memory (feature does not work with module systems).
Servo Sync (feature does not work with module systems)
Preset failsafe system.
Quick Connect
Horizontal-Pin configuration
Red LED indicates number of hold

Binding Procedure:
1. Put the binding harness into connector location marked BATT. Next apply power to the receiver. Receiver LED should illuminate it means bind is accomplished
2. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested). Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.
3. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. All fail-safes should be programed correctly now.
4. Remove binding harness from the BATT channel. Restart the receiver by cycling it power off and turn on and connect battery into BATT channel is recommended. All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. Surfaces and throttle should return to your preset fail-safe positions.

Note:
Only one bind procedure is required on a new receiver. Repetitive binding provides no extra security. Always remember to remove the binding harness after successful bind is completed.

Wireless Simulator Interface(W.D.S.C):
- Main receiver and satellite must connect.
- Receiver must bind with transmitter first (AUX4 channel do not plug binding harness)
- AUX3 is the (W.D.S.C) channel, connect with simulator line
- BIND channel and AUX4 channel plug the binding harness
- Apply power to the receiver with USD line or battery
- Turn transmitter on, now both LEDS keep light and simulator works.

LED Indication:
- Solid illuminated Red LED is indicates good signal. If flashing, 1 flash indicates 1 signal loss, 2 = 2 signal losses and etc....
- The Orange LED on main receiver should flash one time when power is first applied. It will flash several times when binding harness is connected. It should stay illuminated if main receiver losses signal but the Satellite is still working.
- The Orange LED on the Satellite will flash one time when power is first applied. It will flash several times during binding process. It will stay illuminated when satellite is functioning normally.

Package Included:
1x REDCON CM621 Receiver
1X Bind plug
型番 CM621
販売価格
1,000円(内税)
購入数